int in1 = 7;
int inr = 8;


void setup() {
  pinMode(in1, OUTPUT);
  digitalWrite(in1, HIGH);
  pinMode(inr,OUTPUT);
  digitalWrite(inr, HIGH);
}
void loop() {
  digitalWrite(in1, LOW);
  delay(10000);
  digitalWrite(in1, HIGH);
  delay(10000);
  digitalWrite(inr, LOW);
  delay(10000);
  digitalWrite(inr, HIGH);
  delay(10000);
}

bun



 int rfReceivePin=9;  //RF Receiver pin = Analog pin 9
 int ledPin =7 ;     //Onboard motor = digital pin 7
 int rfR=10;
 int ledR=8;

 unsigned int data = 0;   // variable used to store received data
 const unsigned int upperThreshold = 70;  //upper threshold value
 const unsigned int lowerThreshold = 50;  //lower threshold value

 void setup(){
   pinMode(ledPin, OUTPUT);
   digitalWrite(ledPin,HIGH);
   pinMode(ledR, OUTPUT);
   digitalWrite(ledR,HIGH);
   Serial.begin(9600);
 }

 void loop(){
   data=analogRead(rfReceivePin);    //listen for data on Analog pin 0
   
    if(data>upperThreshold){
     digitalWrite(ledPin, LOW);   //If a LOW signal is received, turn LED OFF
     Serial.println(data);
     delay(5000);
   }
   
   if(data<lowerThreshold){
     digitalWrite(ledPin, HIGH);   //If a HIGH signal is received, turn LED ON
     Serial.println(data);
     delay(5000);
   }
   data=analogRead(rfR);

   if(data>upperThreshold){
     digitalWrite(ledR, LOW);   //If a LOW signal is received, turn LED OFF
     Serial.println(data);
     delay(5000);
   }
   
   if(data<lowerThreshold){
     digitalWrite(ledR, HIGH);   //If a HIGH signal is received, turn LED ON
     Serial.println(data);
     delay(5000);
   }
 }

rau